Can You Repair A Cracked Lcd Nintendo 2ds

Introduction

This guide shows how to access the Nintendo 2DS screen for repair and cleaning purposes.

Remove the two Phillips screws securing the upper rear panel.

Hinge the upper rear panel upwards and outwards to remove it.

Hinge the upper rear console upwards and outwards to remove information technology.

Remove the bombardment from its housing past lifting it up from the side closest to the outside edge.

The rear panel is attached to the motherboard past a ribbon cable, so be careful not to elevator the rear panel too far from the device.
Carefully pull the rear console direct upward from the device.

Carefully flip the back panel over to locate the fastened ribbon cablevision.
Remove the ii Phillips screws attaching the ribbon cable to the rear panel.
Take the opportunity to remove the Left and Right triggers, they accept hinges that may break and springs that may leap away.

Hold the side panels of the device'south instance with your fingers and pull outward to remove them.
The panels should come off easily with little force required.

Remove the 12 brass-colored Phillips screws securing the main board.
Be very careful not to strip any of these screws. Stripping can occur very easily, and may brand replacement of the motherboard impossible.

The summit panel can but exist removed when the mother board is non secured.
There are two additional screws located on the top rail. Remove these to fully remove the buttons and height rail.
There are two screws holding downwardly the joystick base of operations that must be removed. (Be careful of the ribbon cable—it stays continued!)
Concord the top panel with your fingers and pull away from the device to remove it.
The top panel should come off easily, with very little force applied.

Detach the 2 ribbon cables by lifting the black flip connectors that hold them.
Lift out the rectangular board seated in the face and elevator out the white square which is the joystick motor (takes a little endeavour). Both stay attached to the motherboard.
On some models, you'll need to remove three more tiny ribbon cables at the lesser of the screen. They are secured past flip up connectors. BE GENTLE!
Property the motherboard on either side, elevator to remove it.

Ensure that the ribbon cables connecting the screen to the motherboard accept been asunder before removing the screen from the front panel casing.
Grasp the screen firmly by a corner and elevator information technology off of the forepart panel of the Nintendo 2DS. There should be slight resistance due to the double side adhesive strip on the screen

Conclusion

To reassemble your device, follow these instructions in opposite order.